Monocoupe 90A
Page 5 Copyright © 2016 Jim Young and T& J Models
Unpin the structures from the board. Fit
the top and bottom F5, F6, F7, F8 pieces
to mate the two sides. Align the rear
section of the fuselage over the plans
and when satisfied, use thin CA at each
puzzle joint to make them permanent.
Bend the forward landing gear from
5/32” music wire and the rear gear from
1/8” music wire.
Fit F3 and F4 onto the cabin floor. Fit
the F9 assembly and F10 in place on the
fuselage floor. Capture the two landing
gear wires with the two F11 fuselage
keels. Fit the cabin ceiling F3A in place.
Making sure each piece is square and
fully inserted in its slot, glue the forward
fuselage structure together. Fit and glue
F1, F1A, F1B, F1C and F2 to the
fuselage. Glue the FW assembly in
place. Add 1/4” balsa doublers to F3.
Bind the landing gear together with fine
wire and solder.
