Monocoupe 90A
Page 6 Copyright © 2016 Jim Young and T& J Models
Assemble the forward spar box making
sure it is wide enough to fit both main
wing spars. Assemble the rear spar box
to F4, again making sure the rear spars
will fit. Fit the forward spar box to the
cabin ceiling and use the R2’s to
position it. Use epoxy to glue the
forward spar box in place. Glue R1,
F4A’s, and F5A’s in place.
Glue the door frame pieces D1 through
D9 in place using 1/64” plywood to
space them.
Glue the front and rear fuselage together.
The F5A’s and F11’s key on to F6.
Sheet the forward portion of the fuselage
with 1/16” balsa. Glue 1/4” balsa L.E.
to the fronts of the R2. Sheet the center
of the wing from the forward spar box to
the L.E. Add 1/16” balsa cap strips to
the tops of the R2’s, F4A’s, and F5A’s.
