T&M PROJECTMIX818, User Manual

9. Monitor ZONE SELECT

Note:

11. Monitor Zone Output Level

The  ZONE SELECT button (9) is used to select
one of the 8 zones to be monitored.Pressing the
zone select button will cycle through allzones in
sequence as follows:1,2,3,4, 5,6, 7, 8, and OFF.

button.Once the display shows the desired zone,
press the ENTER button to confirm and change 
to the selected zone.

returned to its previous setting after 10 seconds.

controlling the audio in a remote zone or testing 
the system.

The Single Digit Monitor Zone LED Display (10) 
will display the selected zone numbers,1-8.

The 5 LED Monitor Zone Output Level Meter(11)
will provide visual indication of the audio signal 
level for a selected zone.

12. Monitor Volume

13. ESC

14. ENTER

15. BGM ALL

Note:

of source select,monitor zone select and BGM 
function buttons.

The BGM ALL button (15) is used to select the 
same source for all 8 zones simultaneously.To
confirm  the BGM ALL selection,press ENTER.

The BGM ALL selection will only be confirmed
after the ENTER  button is pressed ,otherwise 
the source  selection will be return to previous
setting  after 10 seconds.In the event power is
lost, the  BGM  ALL  selection  settings  will be 
saved  and the  unit will  return to the previous 
BGM ALL setting when powe red back on.
 

FRONT PANEL LAYOUT

A zone can be selected pressing the ZONE SELECT

The zone will only change after the ENTER button
is pressed, otherwise the source  selection  will be

The monitor zone function enables the audio output

from a zone to be monitored through  a small speaker

on the front panel.This is particularly useful when

10. Monitor Zone LED Display

The Monitor Volume control knob (12) will control
the in-built Monitor Speaker volume level.

of source select,monitor zone select and BGM 
function buttons.

The ESC button (13) is used to cancel the selection

The ENTER button (14) is used to confirm selection

3