STEP 1
1. Please note that this treadmill need at
least 2 people to finish assembly.
2. Open the carton box, and take out all
the protection foam and assembly parts.
3. As the photo shows, take out the
running deck from the box, lay it on the
flat floor, and then to cut the belt.
STEP 2
1. Lift up the left upright(2) ,Use the allen wrench
6#(24) to attach 1 half round hex bolt M10*50
(12)and 1 flat washer M10(21) on the left upright,
then fix 1 half round hex bolt M10*20 (13) and 1
flat washer M10(21) on the left upright (The step
to assemble the right upright is the same )
2. Do not tightly fasten all the bolts and screws at
this step.
STEP 3
1. Connect the right signal cable in the console
(4) with signal cable in the right upright(3), then
use the Allen wrench (5) to fix 4 half round hex
bolt M8*15 (16) and 4 flat washer M8(20) on the
left /right upright(pay attention to the connection
of the cable on the right upright, a wrong
connection would caused damage of the
connector.
2.Tight all the screw in this step
5
ASSEMBLY INSTRUCTIONS
Summary of Contents for T25CM
Page 22: ...21 EXPLODED DRAWING...
