14
If you want to save a channel under one of the 12 presets, you must press down the button
with the number concerned for two seconds. When the channel has been saved and you
wish to listen to that channel, press the button with the number that you have saved the
channel under. The procedure is the same for both FM and DAB.
Channels that have not been saved can be selected by means of the TUNE knob on the
front panel. Note that if the channel is selected by means of the TUNE knob, you must
confirm your choice by pressing the ENTER button.
Note: If you press and hold the ENTER button for 2 seconds, you will set the auto enter
function on and off. When the auto enter function is on, it is not needed to press enter to
confirm your choice of station.
FM mode
When the radio is on, select FM mode by pressing the MODE button until the message
below appears in the display.
Scanning for station in FM mode
To scan for stations in FM mode, press the AUTOTUNE button to scan up in frequencies.
To scan down in frequencies press and hold the AUTOTUNE button for two seconds. The
radio will stop autotuning when it reaches a station with a adequate signal.
Selecting audio mode on FM
In FM mode press the ENTER button to choose between AUTO and MONO.
When the audio mode is set to AUTO, the radio will in stereo in the headphones and on the
line output when stereo is available. If you choose MONO the radio will force all outputs to
play in MONO.
This function is used if you are trying to received a radio station with a not adequate signal.
Some stations might be better received in mono when the signal strength is not adequate.
AUX mode
The unit has an auxiliary stereo input. This input can be used to connect an external CD
player or similar to. To select the auxiliary input, press the MODE button. Press the MODE
again to change back to listen to radio.
