3
Instruction Guide
Basic Operation
•
Plug the connector into the back of system labelled USB and the power
supply into the mains.
•
Ensure the antenna is extended as far as possible so that you can
rotate it. This will enable you to get the best signal you can. Switch the
button on the rear of the unit to “On”.
•
Press the
Standby
button to turn the unit on. When DAB radio is activated for
the first time, press the Scan button then a full
scan
will automatically
commence, or will play the last station before the unit was turned off.
•
To scroll through the stations, use the
Tune/Enter
button. Press the
Tune/Enter
button to listen to a station.
•
To change the mode, press the
Mode
button.
This will switch between DAB Radio/ FM Radio and Bluetooth mode.
•
The display screen will dim automatically after 10 seconds if left in standby or
working mode.
DAB Radio
•
Press the
Mode
button to switch to DAB Radio. Fully extend the antenna.
•
To auto scan, press the
Scan
button and then release. This will start scanning
up the frequency band and store all stations that have good signal.
•
The radio will automatically save all the stations with a strong signal.
After searching has finished it will automatically play the first station stored.
•
To listen to all stations that have been stored turn the
Tune/Enter
button to
scroll through them. Press the
Tune/Enter button
when on the required
station.
•
The Radio will display station information when you press the
Info/Menu
button. Press multiple times to view all information available.
When you turn the radio on after switching off, it will automatically tune to the
same station (DAB or FM) that was last selected.
In DAB mode, the radio will synchronize with the time and date of the station.
