8
Troubleshooting
Problem
Solution
No sound
•
The station is not tuned in. Fine tune the station.
•
The volume is set to a low position. Increase the volume.
•
Headphones may be connected. Disconnect the headphones.
Buttons a not working
Turn off the unit and turn on again after a few seconds.
FM: Static sound
DAB+: Burbling/
intermittent cut-out
•
Signal reception is too low.Adjust the aerial or move the unit
to a stronger signal location.
•
Rescan stations.
Sound is distorted
The volume is too high. Adjust the volume control.
Desired station not found
Weak signal. Use the manual tune function.
Display shows “No Service”
There is no DAB+ coverage in your area, or poor
reception.Adjust the position of the aerial,or move the unit to a
stronger signal location.
Display is blank
This may occur if the broadcaster changes the label of a
service or removes a lable while tuned.The unit will try to
retuned or perform a scan.
Time and date not setting
automatically
For the time and date to set automatically you need to turn on
the system and switch to DAB radio and let this scan.The date
and clock will update automatically.
