29
Configure menu
Choosing the option you want from the Configure
menu
1.
Press the
SELECT
button.
Note
: if you make a mistake at any point, press the
BACK
button to go
back to the previous screen.
2.
Turn the
TUNE
knob until ‘Configure’ is displayed
3.
Press the
SELECT
button.
4.
Turn the
TUNE
knob until the display shows the option you want.
5.
Press the
SELECT
button to choose the option shown on the display.
The options are explained below.
<Network Config>
Enables you to scan again for connection to another wireless network, or to
manually configure the network parameters. Use this if you take the Internet
radio to another building where you want to use it
The Network Config menu also allows you to choose whether or not the
Internet radio displays a warning message when its network signal strength
is low. You can enable this feature by selecting ‘Signal Warning’ and then
selecting ‘Yes’.
<Version>
Displays the versions numbers of the various parts of software and
hardware on your Internet radio.
<Upgrade Firmware>
Use this option to download new firmware for the radio from the Reciva
portal on the Internet. If there is new firmware available, then the radio will
prompt you if you want to download it or not.
Note
, at this stage, you can
press the radio’s BACK button to cancel the radio beginning a firmware
upgrade. A Firmware upgrade may take several minutes, so do
NOT
switch
off the power to the radio until the operation is complete otherwise the radio
may become permanently damaged.
Summary of Contents for Internet Radio Quattro MKII
