Medix 1700SF User’s manual
35
Load Fail-Safe Defaults
This option allows you to load the troubleshooting default values
permanently stored in the BIOS ROM. These default settings are
non-optimal and disable all high-performance features.
Load Optimized Defaults
This option allows you to load the default values to your system
configuration. These default settings are optimal and enable all
high performance features.
Set Supervisor Password
These two options set the system password. Supervisor Password
sets a password that will be used to protect the system and Setup
utility. User Password sets a password that will be used
exclusively on the system. To specify a password, highlight the
type you want and press <Enter>. The Enter Password: message
prompts on the screen. Type the password, up to eight characters
in length, and press <Enter>. The system confirms your
password by asking you to type it again. After setting a password,
the screen automatically returns to the main screen.
To disable a password, just press the <Enter> key when you are
prompted to enter the password. A message will confirm the
password to be disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
Save & Exit Setup
This option allows you to determine whether or not to accept the
modifications. If you type “Y”, you will quit the setup utility and
save all changes into the CMOS memory. If you type “N”, you will
return to Setup utility.
Exit Without Saving
Select this option to exit the Setup utility without saving the
changes you have made in this session. Typing “Y” will quit the
Setup utility without saving the modifications. Typing “N” will
return you to Setup utility.
