To Test Barcode Scanner Module
1.Click Start | All Programs | Accessories | NotePad to run the Notepad.
Scan one of the several supported barcodes.
2. The output will appear in the Notepad screen.
3.Verify the captured data.
SPECIFICATIONS
The Internal battery pack should only be replaced by an authorized Tangent service
representative. Please contact your product and/or service provider for internal battery
replacement service.
The Default Port Parameters for Barcode Scanner Module
The CMOS Camera is preinstalled as an option for the series.
Note: Please refer to Hyper Terminal Settings to confirm or change the port parameters.
Note: Specifications are subject to change without notice.
Linear Imager Compliance and Precaution
This product complies with the following standards for laser and LED safety.
IEC 60825-1 Class2 LASER Product
Installation
To assign Camera Trigger button, follow the steps below.
1. Start Button Manager by clicking on
in the system tray.
2. Select an available unused button marked with the icon
.
3. Click on
to go to the second screen of Button Manager.
4. Click on the
icon to assign the Camera Trigger to the unused button.
5. Click OK to apply configuration settings and close the window.
Button Management
To test the CMOS Camera, launch DTSMCap Utility from Start | All Programs |
Utilities. Select File | Set Capture File to assign the location of the captured files.
To Test CMOS Camera
Module
> Click Options | Preview to preview the
capture screen.
> Click Devices to select your camera device.
>Take a picture from Snap | Go
> Capture the Video from Capture | Start
Capture to start and Stop Capture to end it.
> You also can trigger from the assigned
button, then edit the captured files
Mobile POS Tablet CMOS Camera
