Eng
11
Eng
10
Setting zero (changes to “State5”)
None
E
None
State0
State1
State2
State5
State6
State7
Action
Message
Start Weighing
Command
Response
Zero is set, awaiting load (changes to “State6”)
S6
When load stabilizes, measurement results are output
(changes to “State7”)
None
Load drops to 2.0kg or less (changes to “State1”)
S1
Check if height has been set
When set
None
G
None
State0
State1
State2
State5
State6
State7
Action
Message
Start BMI Measurement
Command
Response
When not set
E4
Setting zero (changes to “State5”)
None
Zero is set, awaiting load (changes to “State6”)
S6
When load stabilizes, measurement results are output
(changes to “State7”)
None
Load drops to 2.0kg or less (changes to “State1”)
S1
Reset (changes to “State1”)
None
Action
Message
Q
@
State0
State1
State2
State5
State6
State7
Reset
Command
Response
Stop weighing (changes to “State1” or “State2”)
None
Action
Message
q
@
State0
State1
State2
State5
State6
State7
Stop Weighing
Command
Response
Height value set before weighing is stop is retained.
<Error Commands>
Weighing error
E0
Weight limit exceeded
E1
Start BMI measurement command sent without height being set
E4
Set height value exceeds input parameters. BMI under 6.0
E6
7. Troubleshooting
If you are concerned that the scale may not be functioning correctly, please check the following points before requesting repairs.
Problem
Check Points
“-----” is not displayed when the D-8000
is turned on.
The displayed weight is not accurate
The kg/lb button does not function
•Incorrect Pin input for the device you are trying to use.
•The WB-8000RW is off.
•The WB-8000RW’s mode is set to USB ONLY
•The WB-8000RW is not in standby mode
•The WB-8000RW is not in standby mode
•There is interference
•The WB-8000RW has been installed incorrectly
•Please contact a sales office
Err C is shown on D
8000
Err is shown on D
8000
•A transmission error has occurred. Turn the display off.
•An error has occurred. Turn the display off.
Lo is shown on D
8000
•Replace the batteries.
