SPRAY APPLICATOR
STEP 1
Unscrew solution cup and Fill Solution Cup no
more than ½ - ¾ full. Over filling the solution cup
may cause the cup to leak.
STEP 2
Insert Cup into applicator and screw tightly.
Being careful not to cross thread the solution cup
STEP 3
Set the spray pattern by turning the silver nozzle,
aligning the nozzle in a vertical position for
up/down spraying and horizontal position for left
to right spraying.
STEP 4
Adjust Solution Dial behind the trigger to desired
level. Start with the dial hard against the trigger
resulting in maximum solution spraying from the
applicator, then wind out until the desired result is
obtained.
STEP 5
Attach Hose. Insert the hose into the back of the
spray applicator until firmly in place.
