TOWER ASSEMBLY
www.tanningessentials.co
STEP 1
Lay the floor into position, the wide straight edge is
the front.
STEP 2
Using the handle, place the base unit on the back of the
floor with the hollow side facing down.
STEP 3
Locate your two fan units and top unit, picking them up
with the handles located on the back, place the first fan
unit onto the base, lining it up with the grooves – make
sure it is securely in place with no movement.
STEP 4
Locate the metal bars and align them with the holes on
the side of the station. Loosely screw the metal bars to
the base unit and the fans using the screws provided.
Note: Only loosely screw the rails into position, allowing room to
insert the sides and only tighten after the sides are in place.
Stack the next fan unit on top of the first one. And the top
unit on the second one so you have a total of three units
on top of the base.
Ensure the red filter release buttons are on the right hand
side when looking at the front of the station.
