6. Installation
8
CMS 3.0 Series Operation Manual rev 3.0.0
6. Installation
6.1. Installation Guide for Suspended Ceilings
1. Remove the ceiling tile from its frame and place it on a flat
surface. Position the cutout template (self adhesive backed) on
the tile. (Fig.1)
2. Cut out the hole in the ceiling tile using a pad saw following
the broken line indicated on the template (Fig.2)
3. Place the C-Ring and tile-bridge on top of the ceiling panel,
aligning the C-Ring over the hole, and screw the C-Ring to the
tile bridge using the fixings provided. (Fig.3)
4. Go to section 7 for instructions on wiring and set-up instructions.
5. Slide the speaker assembly through the hole. Turn the screws
(denoted “Screw Fix”) clockwise on the front of the speaker
to extend the mounting wings. Tighten the screws until a firm
grip is achieved. (NOTE: Screws have a PoziDriv head; use of a
PoziDriv driver is recommended). If using a power driver, Tannoy
recommends a torque setting of 1.5 Nm. (Fig.4)
DO NOT OVERTIGHTEN!
6. Attach the nylon safety to the hooks on the front baffle
before attaching the grille by presenting it to the speakers and
allowing the magnets to pull it into position (Fig.5). (With the
CMS 403DCe/ICTe, the grille is already fitted to the product.)
NOTE ON INSTALLATION OF CMS 403DCe/ICTe:
Before tightening the screws in step 5, swivel the speaker in the
desired direction. When the screws are tightened, the speaker will
lock into position. Replace the front trim to conceal the mounting
screws.
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5