Tannoy IW60EFX, User Manual

5

INSTALLATION

GUIDELINES

1. Fit the pre-install bracket frame to the 2ft x 4 ft

wooden studs by using suitable fixings (fixings

not supplied). 

See Fig 1

SAFETY NOTICE:  The user is responsible for

fixing the hardware to the surface to ensure safe

operation. 

2. Lay the cables 

(i) Lay the loudspeaker cable from the amplifier

to the installed pre-mount frame. See point 5 for

connection instructions.

(ii) 

iw60EFX only

: Note that the iw60EFX

features a 12V relay switch which allows the

speaker to toggle between “Cinema” and

“Music” modes if the AV receiver supports this

function.  To use this facility you will need to lay

two-core loudspeaker cable from the AV receiver

to the first iw60EFX pre-mount frame then lay

loudspeaker cable from that location to the next

iw60EFX pre mount frame to allow daisy-

chaining.  See point 6 for connection

instructions.

NOTE: The pre-install frame has four 21mm

diameter holes to accommodate cables or even

conduit, if required (two are positioned at the top

and at two are positioned at the bottom).  These

holes are blocked off by grommets.  Simply

knock out the appropriate grommets and pass

the cables or conduit through the appropriate

holes

3. Complete the wall, leaving the pre-install

frame exposed. 

See Fig 2

4. Connect the loudspeaker cables.  The positive

terminal on the amplifier channel ( or

coloured red) must be connected to the positive

terminal on the loudspeaker (coloured red).  The

negative terminal on the amplifier channel

(marked - or coloured black) must be connected

to the negative terminal on the loudspeaker

(coloured black). pre-install frame exposed. 

See

Fig 3

Fig 1.

Fig 2.

Fig 3.

definition inwall manualv2.qxd:Layout 1  25/10/07  11:30  Page 5