5. Interface Panel
VSXNET Subwoofer Operation Manual rev 2.0.0
5
5. Interface Panel
CM
I N T
E R TEK
LI ST E D
C
US
THIS CLASS D DIGITAL DEVICE MEETS ALL REQUIREMENTS OF THE
CANADIAN INTERFERENCE-CAUSING EQUIPMENT REGULATIONS AND
COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION SUBJECT TO CONDITIONS STATED IN THE MANUAL.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS
OUVRIR.
CAUTION
MANUFACTURED IN THE UNITED KINGDOM
- LIMIT
- SIGNAL
- POWER
FUSE
T10AL 250V
USER DSP
ON - OFF
INPUT
LINK
NETWORK
IN
NETWORK
LINK
THIS EQUIPMENT MUST BE EARTHED
A green signal present LED,
operating at -50 dB relative
to the minimum input level
XLR female audio input
XLR male audio link
RJ45 network input
RJ45 network link
Rocker power switch
Rugged Neutrik Powercon
locking mains connector
Fuse Holder
A user DSP ON/OFF
switch
In the OFF position this will
return the loudspeaker to
the factory default settings
A ‘NETWORK FOUND’ LED,
mounted on the front of the
cabinet, software controlled
to enable location of specific
nodes on the network
Amplifier & DSP Panel
Power LED
A ‘LIMIT/NETWORK
FOUND’LED displays
DSP limiter action for both
output channels. Also
duplicates the function of
the front mounted network
found LED
A ‘LIMIT/NETWORK
FOUND’LED displays
DSP limiter action for both
output channels. Also
duplicates the function of
the front mounted network
found LED
• XLR FEMALE AUDIO INPUT — This is a lockable
XLR line input socket for connection to the audio
source. Fully Balanced.
Pin 2 Hot (+), Pin 3 Cold (+), & Pin 1 Ground.
• XLR MALE AUDIO LINK - This is a lockable XLR
line output socket to link additional speakers.
Fully Balanced.
Pin 2 Hot (+), Pin 3 Cold (+), & Pin 1 Ground.
• RJ45 NETWORK INPUT - For Control and
monitoring functions over RS485.
• RJ45 NETWORK LINK - For linking cabinets.
Vnet supports free network topology. Cabinets can
be daisy chained or linked in a star configuration, or
a combination of both.
• ROCKER POWER SWITCH — Turns AC power on
to the unit (100 V — 240 V)
• FUSE HOLDER — Replace only with 10A 230 V
anti-surge fuse. Tannoy part Number 3461 0919.
• AC MAINS CONNECOR — Neutrik Powercon
mains connector (supplied)
• USER DSP ON/OFF SWITCH
• POWER LED — Blue LED indicates when power
has been applied to the speaker.
• LIMIT/NETWORK FOUND LED — Also mounted on
the front of the cabinet. This can be seen clearly
from behind the grill when activated.
• SIGNAL PRESENT LED
