VXP 6
VXP 6 // issue 1.00 // 20.02.12
Tannoy (Direct UK)
T: +44 (0) 1236 420199
E: enquiries@tannoy.com
TCGI (ROW sales)
T: +45 8742 7000
E: info@tcgroup-international.com
TCGA (Americas sales)
T: +1 (519) 745 1158
E: info@tcgroup-americas.com
Tannoy Middle East
T: +971 (04) 4401208
E: enquiries@tannoy.com
The loudspeaker shall consist of a 150 mm (6”) full-range, point source Dual Concentric transducer. The low and high frequency elements
shall be driven by an integrated single-channel Class D amplifier through an internal passive crossover network operating at 1.6 kHz. The amplifier
module shall incorporate an auto power down (APD) circuit that places the loudspeaker in standby mode with less than 1 W power consumption
when input signal is absent for more than 20 minutes, resuming full operation when signal is again present at the input.
Performance of the loudspeaker shall meet or exceed the following criteria: Frequency response measured at 1 metre on axis with swept sine wave
shall be 88 Hz to 35 kHz (3 dB) in full range mode and 120 Hz to 35 kHz in high pass mode. Rated average SPL shall be 112 dB (anechoic) on axis
at 1 metre. The dispersion of the loudspeaker shall be 90 degrees conical (-6 dB).
The enclosure shall be an optimally tuned 9.2 litre vented birch plywood cabinet. Connectors shall be 1 x female XLR (input), 1 x male XLR (link)
and 1 x Neutrik powerCON. The speaker shall be fitted with the following controls and indicators: level control, blue power LED, green signal LED,
red limit LED, full-range / high-pass switch (110 Hz) and a power switch. The enclosure shall be fitted with 4 x integral M6 inserts for flying hardware
and 2 x M6 yoke bracket inserts. There shall be a blanking plate for an optional pole mount adaptor.
The enclosure shall not exceed the following dimensions: 33 x 225 x 215 mm or 13.1 x 8.9 x 8.1” (H x W x D). The loudspeaker shall be the
Tannoy VXP 6.
Architect’s and Engineer’s specifications
