O P E R AT I O N O F H E AT E R
Please refer to the separate manual(s) provided to connect your remote to the
heaters built-in receiver.
5
CAUTION:
Only operate the heater with the remote handset when you have a
clear view of the heater to ensure there are no obstructions or hazards on, in front
of or around the heater.
M AI N T E N A N C E
In the event of heater failure, or for spare parts or advice, please contact your
distributor in the first instance.
Disconnect from the mains before commencing any maintenance procedure including
cleaning.
To ensure optimum heat effectiveness, it is recommended that that the guard and
emitter are removed and the reflector is wiped with a lint-free cloth before
reassembling should the reflector show considerable signs of dust or dirt.
H AN D L I N G T H E R E P L A C E M E N T E M I T T E R ( L A M P )
Your new emitter (lamp) should not be handled with bare hands.
Remove finger marks with a soft cloth and methylated spirits or rubbing
alcohol. Finger marks will burn into the emitters (lamps) quartz glass
causing premature failure.
Y O U R R E P L AC E M E N T E M I T T E R ( L AM P )
It is very important that your replacement emitter (lamp) is exactly the same as the
one it was supplied with. Failure to fit the exact same type could cause the heater to
fail or even become dangerous especially when used in an outdoor environment.
Please contact your distributor to purchase your replacement emitter (lamp) and state
the model number of the heater you wish to fit the emitter (lamp) to.
R E P L AC I N G T H E E M I T T E R ( L AM P )
If you are in any doubt about following the procedure below, please contact us
for technical assistance. The mains power should be disconnected before any
attempts are made to replace the emitter (lamp). The following should be
carried out with compliance to the latest electrical regulations. Please read the
notes on the previous page with regards to handling and buying a replacement
emitter before proceeding. We also recommend you read through the procedure
before commencing work.
1
. Ensure the mains power is disconnected and the heater and emitter (lamp) are
cool.
2
. Remove the 4 × screws (Fig. C) from the endplate on the terminal box end of the
heater and remove the endplate.
7
