3
Charging:
Please charge the scanner at least 30 minutes before use to
ensure that the scanner has enough power. To charge the
device, connect the scanner with USB charging adapter or
active USB port by using the supplied cable. The Red LED will
turn ON during charging and the LED indicator will turn green
after full charge. The scanner can be fully charged in around 2.5
hours.
Note:
1. Please use computer USB interface or 5V DC power adapter
for charging, other wrong power adapters will cause permanent
damage to scanner and battery.
2. The USB cable can be used for charging and receiving the
data.
3. When the top red indicator light cyclically flashes three times
and beeps continuously, it means the battery is at low power.
Please stop using and recharge it.
Quick Start Guide
This scanner supports 3 connections: Bluetooth mode, 2.4Ghz
wireless mode and USB wired.
When turn the scanner on for the first time, the scanner will enter
into Bluetooth pairing by default.
We highly recommend you to use 2.4GHz wireless mode on the
computer, use Bluetooth mode on the smartphone, tablets.
1. Bluetooth mode quick start guide
--To use the scanner on Android / iOS device
STEP1. Turn on the scanner
STEP2. Turn on the Bluetooth of your device and search the
scanner that should show as“B
PBL0
2, and click it to connect.
2
Wait few seconds, the scanner will beeps twice, which means
Bluetooth pairing is successful.
STEP3. Test the scanner using Notes app (iOS) or Microsoft
Excel (Android), click on any cell and then scan a barcode to see
if the barcode comes up on the cell.
Note 1: Once the pairing is successful, the keyboard of your
device will disappear. Scan the following code, the soft keypad
will show up; scan the code again, the soft keypad will be
hidden.
To show or hide iOS keyboard.
Disconnect Bluetooth.
2. 2.4GHz wireless mode quick start guide
--To use the scanner on computer
If you want to use the scanner on computer, please set up the
scanner wireless according to the following steps.
STEP1. Scan the following code “Disconnect Bluetooth” to
change the connection mode from Bluetooth mode to 2.4Ghz
wireless mode.
STEP2. Plug the USB receiver into USB port of your computer
STEP3. Open a blank Microsoft Excel, click any cell and then
scan a barcode to see if the barcode comes up on the cell.
