TaoTronics TT-AH026, User Manual

13

14

TROUBLESHOOTING GUIDE

1. If the information listed in the troubleshooting guide can’t solve your 
    problem, please email us for help.
2. Failure to keep this unit clean from mineral deposits may affect operation 
    of this unit. 
3. Customer failure to follow these instructions may void the warranty.

1

2

1. Spring  
2. Sealing ring

Not enough water
inside the tank

Refill and reinstall the
water tank

The LED Indicator is
yellow but no mist or
little mist is produced

Mist level is set too low

Adjust to maximum mist

Mineral buildup on the 
atomizer

Feel if any air comes out
from the nozzle. If yes, then
clean water scale on the
atomizer as instructed

The base might be
overfilled

Remove the tank, empty
the base and place the
filled tank on the empty
base

Tank leakage

Tank may be damaged

Check for possible
cracks in the tank, 
replace if necessary

Tank cap is not
tightened securely

Tighten the tank cap

     Spring stuck

Ensure the      spring is 
properly secured to the
tank bottom allowing
water to pass through to
the base.

1

1

     Sealing ring was not 
installed on tank cap

Install the      sealing ring
on the tank cap, please
contact us if it is missing

2

2

Mist level is set too high
for the room size

Air inlet is blocked

Humidifier should be
placed on a hard flat
surface, 2 feet above the
floor, 12 inches away from
the wall. Point nozzle away
from wall or window

Low indoor temperature 
leads to liquefaction

Raise the room
temperature to 25°C / 77°F

Mist height is low, 
damping surrounding
desk or floor.
Condensation forms
around humidifier or on
windows and walls

1. Check if the room is too 
    humid and adjust to
    lower mist. 40%-60%
    works best
2. Open door and
    windows, or change to
    a larger room

Problem

Possible Cause

Solution

Unit not plugged in

No power from power
outlet

Did not turn on the unit

Ensure unit is properly 
plugged in

Try another power outlet

Rotate the Control Knob
clockwise to turn on the unit

LED indicator is off

Ensure the      Spring is 
secured properly to the
tank bottom allowing
water to pass through
to the base

1

No water in the water 
reservoir

LED indicator stays red