b) Charging the battery
•
When using for the first time, it is recommended to fully charge the product once.
• Charge the portable charger at the latest when only 25 is displayed and the battery level thus
falls below 25 %.
• To charge the portable charger, a USB charger (not included) is required. A USB charging
cable (Micro USB to USB-A) is included.
• Use only the Micro USB input
(3)
to charge the portable charger. Plug the Micro USB
connector of the USB charging cable into the Micro USB input.
• Plug the USB-A connector of the USB charging cable into a USB-A port of a USB charger.
Observe the technical data.
A USB charger with 2 A is recommended for the portable charger input current. If a
lower input current is used, charging will take longer. However, a higher input current
than 2 A will not reduce the charging time since the input current is limited.
• With a 2 A USB charger and a remaining battery capacity of approx. 20 %, the portable
charger can have the following charging times:
-
Item No. / Model 1001CTF (6000 mAh): up to approx. 3.5 – 4 hours
-
Item No. / Model 1002CTF (10000 mAh): up to approx. 5.5 – 6 hours
-
Item No. / Model 1003CTF (15000 mAh): up to approx. 7.5 – 8.5 hours
Check the model you have purchased. While charging, the current battery level will be
indicated by the corresponding percentage flashing on the display.
• Once the battery is fully charged, the battery level indicator will be lit steadily.
• Disconnect the connected cables. The battery level indicator will go off after approx. 40 seconds.
c) Charging a mobile device
• Plug the USB-A connector of the USB charging cable into one of the USB-A outputs
(1)
.
The maximum charging current (2.7 A) is distributed to the USB outputs when both
outputs are used. Therefore, take note of the amount of charging current required by
your mobile device. Observe the technical data.
• Connect the Micro USB connector to your mobile device.
• While charging, the battery level of the portable charger will be indicated by the corresponding
steadily lit percentage.
• Disconnect the USB charging cable from the connected product and the portable charger to
stop or interrupt charging.
• When the USB charging cable is disconnected from the portable charger, the battery level
indicator will go off after approx. 40 seconds.
Care and cleaning
• Disconnect the product from connected products and from the power supply before every
cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as
they can cause damage to the housing and malfunctioning.
•
Clean the product with a dry, fibre-free cloth.
• When cleaning, be sure to avoid contact with water or other liquids.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Input voltage/current
.....................
Micro USB input 5 V/DC, 2 A
Output voltage/current
..................
USB-A output: 5 V/DC, 2.4 A per port
Both USB outputs combined max. 2.7 A
Operating conditions ..................... 0 to +40 °C, 20 - 90 % RH
Storage conditions ........................ -10 to +55 °C, 20 - 90 % RH
Item No. / Model No. 1001CTF
Internal battery ..............................
lithium polymer (Li-Po) / 6000 mAh
Dimensions (L x W x H) ................
125 x 67 x 15 mm
Weight ..........................................
148 g
Item No. / Model No. 1002CTF
Internal battery ..............................
lithium polymer (Li-Po) / 10000 mAh
Dimensions (L x W x H) ................
148 x 73 x 17 mm
Weight .......................................... 254 g
Item No. / Model No. 1003CTF
Internal battery ..............................
lithium polymer (Li-Po) / 15000 mAh
Dimensions (L x W x H) ................ 154 x 75 x 22.5 mm
Weight .......................................... 311 g
These operating instructions are a publication by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower
2, Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems require
the prior written approval by the editor. Reprinting, also in part, is prohibited. These operating instructions represent the
technical status at the time of printing.
Copyright 2018 by CEI Conrad Electronic International (HK) Limited
*1001_1002_1003CTF_1629000_1628888_1604593_v1_0518_02_hk_m_en
Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
