SF-2200H Flame / Plasma CNC Cutting System Operating Manual
2
7) The inside power source of CNC system does not allow connecting with other
electric apparatus.
8) Toward some area that power supply is nonstandard (such as zero line and
earth wire sharing or no zero line), in order to ensure control system working
normally and improve system reliability and sure operator
’s safety, you must
use isolation transformer that three-phase/two-phase AC380V transfer to two-
phase AC220v between electric network and control system.
9) If problem existed, please contact our company. If don
’t familiar with system,
are not allowed to take down system.
10) Output voltage for the control system is suitable only for use of the USB Disk;
and is not supposed to connect with other USB devices to avoid unexpected
damages.
11) Power of the system must be turned off while switching between touchpad
keyboard and exterior keyboard.
12) This operating manual is the property of Beijing Microstep Control
Technology. The final explanation right of this manual belongs to Beijing
Microstep Control Technology.
