PowerFix PEK 2.3 A1
English - 13
Use of the device
Switching the endoscope camera on and off
The endoscope camera is switched on and off by pressing the on/off switch
[3] for approximately 2 seconds. The power indicator [2] lights up green and,
after a short delay, the image is shown on the screen [1].
Lighting
The camera head is equipped with 4 LEDs. This lighting can be switched on
with the camera head illumination button [5]. This button can also be used to
gradually increase the brightness of the LEDs by pressing it several times.
8 different levels can be set. When the highest level is reached and the camera
head illumination button [5] is pressed again, the lighting switches itself off.
Screen brightness
The brightness of the screen can be changed with the brightness adjustment
display button [7]. The brightness of the screen is gradually increased when
this button is pressed several times. 8 different levels can be set. When the
highest level is reached and the brightness adjustment display button [7] is
pressed again, the brightness adjustment is reset to the default value.
Changing the display
The camera image can be rotated by 180° and mirrored vertically or
horizontally by pressing the view/rotate image button [4]. This setting enables
you to display four different views of your image. If the display is changed, the
default display is shown after the camera has been switched off and then
switched on again.
Video-out function
You can use this function, for example, to display the images of the camera on
a TV. Depending on the device on which you want to perform the playback,
you will require a connection cable which must have a 3.5mm jack plug on
one side for connecting to the video-out port [9] of the endoscope camera. The
other connector may vary depending on your playback device. For further
Summary of Contents for 107122
Page 1: ......
Page 2: ......
Page 3: ...V 1 1 English 2 Polski 20 Magyar 39 Česky 58 Slovenčina 77 Deutsch 95 ...
Page 116: ......
