21
EN
PROJECTING AN IMAGE (BASIC OPERATION)
2. Press the “ok” button to execute the selection.
After this has been done, you can proceed to the menu operation.
If you want, you can select the menu language later. See «Language» on page 36.
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5
minutes until the lamp lighting is stabilized.
When the Lamp mode is set to Eco, the Lamp indicator will light green.
If one of the following things happens, the projector will not turn on.
* If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In
this condition the projector will not turn on to protect the internal system. If this happens, wait for the
projector’s internal components to cool down.
* When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the
lamp.
* If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full
minute and then turn on the power.
Summary of Contents for PD-2810W
