27
EN
PROJECTING AN IMAGE (BASIC OPERATION)
Tur ning off the Projector
To turn off the projector:
First, press the “ON/stand by” button on the projector cabinet or the “power” button on the remote control.
The “Power Off / Are you sure?” message will appear.
Second, press the “ok” button or press the “ON/stand by” or the “power” button again.
The power indicator will glow orange. After the projector turns off, the cooling fans keep operating for 90
seconds (Cooling-off time).
NOTE: To avoid premature lamp failure, wait at least 5 minutes before turning on or off the projector.
Third, turn off the Main Power switch. The power indicator will go out.
CAUTION
Do not unplug the power cable from the wall outlet or do not turn off the main power under any one of
the following circumstances. Doing so can cause damage to the projector:
• While the projector is turned on.
• While the cooling fans are running. (The cooling fans continue to work for 90 seconds after the
projector is turned off).
After Use
Preparation: Make sure that the projector is not turned on.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt feet if extended.
4. Cover the lens with the lens cap.
5. Put the projector and its accessories in the supplied soft carrying case.
Summary of Contents for PD-2810W
