1
Troubleshooting
2
3
4
5
6
A
B
B 8
The system freezes.
possible cause:
The systems power saving features have timed-out.
indicator:
The power switch indicator is flashing.
solution:
Use the AC adapter, press the suspend (
Fn+F10
) key
combination. If the indicators light is not on, it is in the
Suspend to Disk
mode, then press the power switch but-
ton to reboot the system again.
possible cause:
The system has crashed because of a software conflict.
solution:
Consult your operating system manual. As a last resort,
since you will lose any unsaved data, try to reboot the
system or if that doesnt work, turn the computer off and
on again.
possible cause:
The system cannot access the
Suspend to Disk
partition.
indicator:
The system retrieves
Suspend to Disk
information very
quickly during bootup and then freezes.
solution:
This situation usually happens after one of the follow-
ing occurs and you activate the
Suspend to Disk
pro-
cess: (1) the hard disk has been changed; or (2) there
has been a CMOS failure or a Checksum failure and
the problem has not been corrected. When one of the
above occurs, you must run the
0VMAKFIL
utility as soon
as possible. Refer to Setting up for
Suspend to Disk
in
Chapter 5: Power
.
operation
