1
2
3
4
5
6
A
B
B 9
The
Suspend-to-Disk
function does not work.
possible cause:
The system cannot access the
Suspend to Disk
partition.
indicator:
When you press the suspend key combination, normal
Suspend to RAM
is activated instead of
Suspend to Disk
.
solution:
(1) Check if you have enabled
Suspend to Disk
in the Power
Savings menu in
Setup
. Refer to
Chapter 4: Firmware
.
(2) You may not have set up the
Suspend to Disk
parti-
tion. Refer to
Chapter 5: Power
to setup the partition.
(3) You installed a different hard disk with a
Suspend to
Disk
partition on it or there has been a CMOS or Checksum
failure. You must run the
0VMAKFIL
utility after one of
the above conditions.
The system never goes into
Suspend
mode.
possible cause:
Power management features are not enabled.
solution:
Go to the
Setup
s Power Savings menu and enable the
features you prefer. Refer to the Power Management
section of
Chapter 5: Power
.
The system does not go into
Suspend to RAM
or
Suspend to Disk
when the
battery is low.
possible cause:
Suspend Timeout is disabled.
solution:
Use one of the Power Management presets or manually
set the Suspend Timeout in the Power Savings menu in
Setup
. Refer to
Chapter 4: Firmware
and
Chapter 5: Power
.
operation
