1
2
3
4
5
6
7
8
3 5
¯
Replacing a HDD
You can replace your HDD with another 2.5,
12mm high IDE hard disk drive.
To assemble the cartridge,
1. Make sure the HDDs jumper pins are set
to master or device 0. Most drives
dont require any settings, but check your
HDDs documentation to be sure.
2. Holding the HDD (1) at an angle (elec-
tronic side up), plug its pins into the con-
nector (2). Make sure all the pins are in-
serted fully.
3. Cover the HDDs electronic component
side with the mylar shield.
4. Insert the HDD and shield combination
into the frame (electronic side up). As you
do so, carefully fit the edges of the shield
around the screw holes of the frame.
5. Secure the HDD, shield and frame with
the four mounting screws (3)-(6).
R
EPLACING
/U
PGRADING
THE
C
ARTRIDGE
If youre too harried or a bit of a
technophobe, contact your dealer to pur-
chase or replace your current HDD with
an upgrade.
main HDD
A
SSEMBLING
THE
HDD
C
ARTRIDGE
F
IG
. 3 4
M
Warning
Depending on the HDD,
the cartridge jumper
must be set to master
or the system will not
recognize it. Check your
drives documentation.
6
4
3
2
1
ñ
5
