Target DocShred TG212-CD, Instruction Manual

- 3 - 

Setup: 

1. Place the CD/DVD & Credit card shredding plas c bin provided with your shredder, inside 

the appropriate rib posi n a ached to the inside of waste bin. 

2. Place the shredder securely on top of the waste basket. Be sure not to allow your 

fi

ngers 

to get between the basket and the shredder as you are placing the shredder in place. 

3. Plug the power cord into any standard 230V~240volt  AC outlet. 

Opera ng the shredder: 

1.

2.

REV

 is used to assist in the removal of a paper jam, which reverses the shredder process 

prior to a completed cycle, thus clearing the cu ers. 

3.

OFF

 is used to terminate the power to the shredder. The mode is recommended when 

emptying the wastebasket or when the shredder is not in use for a prolonged period of 

e.  

Shredder capacity: 

C156-D will shred twelve (12) sheets of A4 size 80g/m

2 

paper, a CD/DVD or credit card at once 

and will accept paper widths up to 223mm. When shredding small material like envelopes or 

receipts, insert them through the middle of the feed opening.  

Paper Jams and overload protec on: 

1.

2.

Both abnormal operations may result in the activation of the automatic motor overheat/

overload protection, which terminates the power to the unit .If this occurs, you should:

Exceeding the shredding capacity, under this situation, the shredder may occur overload,

e.g. inserting more than eight (8) sheets at one pass, or if the paper is not fed squarely 

into the feed opening.

Operating the shredder at the maximum capacity continuously for a prolonged period of 

time, under this situation, the shredder may occur overheat, and the POWER(OVERHEAT) 

Indicator will be flash. e.g. More than 4 minutes for computer paper and CD/DVD or credit 

card without stopping.

C156-D is equipped with a motor overheat and overload protection device, and with a POWER

(OVERHEAT) Indicator. The normal short duty cycle for continuous shredding at maximum 

capacity is 4 minutes. The power may terminate automatically and the in case of the following 

abnormal situations :

When 

AUTO

 is selected, the POWER (OVERHEAT) LED will be light, the shredding process

is started automatically by inserting the paper, a credit card or a CD/DVD into the feed 

opening. When inserting papers, please do not shred CD/DVD and credit card at the same 

time. When inserting CD/DVD and credit card, also please do not shred paper at that time. 

The shredder will stop automatically when the paper, a credit card or a CD/DVD has 

completed its travel through the feed opening.

The Main Switch and POWER (OVERHEAT) LED are located on the top of the shredder

. The 

M

ain 

S

witch has three (

3) settings.