8
SAFETY FIRST!
WARNINGS
DO’s and DO NOT’s
WARNING:
FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING
INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY.
DO
DO
Read this entire operator’s manual before operating this machine. Understand all warnings, instructions, and controls
.
DO
keep all guards in place and in good condition.
DO
wear safety-approved hearing, eye, head and respiratory protection.
DO
read and understand all warnings and instructions on the machine.
DO
read and understand the symbol definitions contained in this manual.
DO
keep all parts of your body away from the blade and all other moving parts.
DO
know how to stop the saw quickly in case of emergency.
DO
shut off the engine and allow it to cool before refueling.
DO
inspect the blade, flanges and shafts for damage before installing the blade.
DO
use only steel center diamond blades manufactured for use on concrete saws
DO
use only the blade flanges supplied with the saw. Never use damaged or worn blade flanges.
DO
use only blades marked with operating speed rated at 5000 RPM or higher. Maximum 8" diameter, 5/8" arbor.
DO
verify saw drive configuration by checking blade shaft RPM, pulley diameters, and blade flange diameter.
DO
read all safety materials and instructions that accompany any blade used with this saw.
DO
inspect each blade carefully before using it. If there are any signs of damage or unusual wear,
DO NOT USE THE
BLADE.
DO
mount the blade solidly and firmly, Wrench tighten the arbor nut.
DO
make sure the blade and flanges are clean and free of dirt and debris before mounting the blade on the saw.
DO
use dry cutting diamond blades with a 5/8 diameter arbor only. Never use damaged or worn blade flanges.
DO
use the correct blade for the type of work being done. Check with blade manufacturer if you do not know if blade is
correct.
DO
use caution and follow the instructions when loading and unloading the saw.
DO
operate this machine only in well ventilated areas.
DO
instruct bystanders on where to stand while the saw is in operation.
DO
establish a training program for all operators of this machine.
DO
clear the work area of unnecessary people. Never allow anyone to stand in front of or behind the blade while the
engine is running.
DO
move the machine at least 10 feet (3 meters) from the fueling point before starting the engine and make sure the gas
cap on the machine and the fuel can is properly tightened.
DO
make sure the blade is not contacting anything before starting the engine.
DO
use cautions when lifting and transporting this machine.
DO
always tie down machine when transporting.
DO
always check for buried electrical cables before sawing. If unsure, contact the local utilities.
DO
clean the machine after each day’s use.
DO
always give a copy of this manual to the equipment user. If you need extra copies, call TOLL FREE 1-800-288-5040.
