Targus Wireless Multimedia Presenter with Trackball
Troubleshooting
What do I do if the presenter does not work?
• Make sure that the polarity of the batteries is correct. The
positive (+) and negative (-) endsof each battery must
match the positive (+) and negative (-) connections in
the batteryhousing.
• Check that the receiver’s USB connector is firmly
attached to the USB port on yourcomputer.
• Verify that the device drivers are installed.
• Make sure you have established a communications link
between the presenter and itsreceiver. See “Establishing
a Communications Link”.
• Turn off any wireless devices and their base units that are
near the presenter’s receiver.
• Increase the distance between the presenter’s receiver
and the rest of your computerequipment. Use the USB
extension cable if necessary.
• Make sure that the presenter is within 20m of its receiver.
• Replace the batteries.
What do I do if the response time of the
presenter is slow or the presenterintermittently
stops working?
I can’t use the presenter while another RF
device is in use – what should Ido?
• Reestablish a communications link. The presenter has
4096 identification codes that allowit to operate without
interference from other radio frequency devices. The
presenter and itsreceiver must be set to the same identifica-
tion code to function properly. To reestablish acommunica-
tions link, See “Establishing a Communications Link”.
13
