Windows Setup
To ensure the best Windows performance, please be sure to update your host PC
BIOS (Firmware), display adapter driver. Using the Windows Control Panel
Display Screen Resolution window, the connected monitors can be configured to
either mirror your main screen, or extend the Windows desktop allowing visibility of
more applications at the same time.
Screen Resolution window allows full configuration of all displays monitors, including:
• Display orientation and location modification
• Layout of displays
• Resolution up to
Single display mode:
- Dual Mode DisplayPort (DP++) or USB-C by DP alternative mode on
Thunderbolt 3 port: 4096 x 2160 p60 max.
Thunderbolt 3 port: 5188 x 2880 p60 max
Dual display mode:
- 4096 x 2160 p60 max can be achieved using dual display mode.
User can connect second monitor to TBT 3 daisy chain port by,
1. Thunderbolt 3 monitor (resolution at 4096 x 2160 p60 max)
2. USB-C monitor with DP alt. mode supported (resolution at 4096 x 2160
p60 max)
3. DP via Targus ACA932 (resolution at 4096 x 2160 p60 max)
4. HDMI via Targus ACA933 (resolution at 4096 x 2160 p60 max)
5. VGA via Targus ACA934 (resolution at 1920 x 1200 max)
Remark: Some laptops / Tablets with only one TBT 3 port do not support dual
stream video output, consult with laptop / tablet manufactures for the dual video
support using this method. In this scenario, alternative method can be used.
Alternative method
Connect DP MST enabled monitor to DP port of DOCK220, additional DP 1.2
monitor could be daisy chained to the first monitor. Resolution will be limited due
to the bandwidth of DP signal.
OS-X Setup
Three Year Warranty
Declaration of Conformity
Regulatory Compliance
Product Registration
FCC Statement (Tested to Comply)
Technical Support
For technical questions, please visit:
US
Australia
New Zealand
Internet: http://targus.com/us/support
Internet: http://www.targus.com/au/support
Email: infoaust@targus.com
Telephone: 1800-641-645
Telephone: 0800-633-222
Targus recommends that you register your Targus accessory shortly after
purchasing it. Go to:
http://targus.com/us/product_registration
You will need to provide your full name, email address, country of residence and
product information.
We pride ourselves on the quality of our products. For complete warranty details
and a list of our worldwide offices, please visit www.targus.com. Targus product
warranty does not cover any device or product that is not manufactured by Targus
(including, but not limited to, laptops, smartphones, devices, or any other product
that may be used in connection with the Targus product). Australian customers:
For complete warranty details see warranty statement enclosed.
Targus is a registered trademark of Targus International LLC in the U.S. and in
certain other countries. Microsoft, Windows, and Windows Vista are registered
trademarks or trademarks of Microsoft Corporation in the United States and/or
other countries. Broadcom and the Broadcom logo are trademarks of Broadcom
Corp. Bluetooth and the Bluetooth logos are trademarks owned by Bluetooth SIG,
Inc., U.S.A. and licensed to Broadcom Corp. All logos and registered trademarks
are the property of their respective owners. ©2017 Targus, 1211 North Miller
Street, Anaheim, CA 92806. All rights reserved.
AUSTRALIAN AND NEW ZEALAND CONSUMERS ONLY
Thank you for your purchase. Targus warrants to the original purchaser that its
products are free from defects in materials and workmanship, during the specified
warranty period, and lasts as long as the original purchaser owns the product. The
warranty period is stated on the packaging or in the documentation provided with
this Targus product. Targus’ Limited Product Warranty excludes damage caused by
accident, neglect, abuse, misuse, improper care, normal wear and tear, ownership
transfer, or alteration. The limited warranty also excludes any product that is not
manufactured by Targus (including, without limitation, laptops, smartphones,
devices, tablets, or any other non-Targus item) that is used in connection with the
Targus product.
In the event that the Targus product has a defect in materials or workmanship
Targus will, after receiving a warranty claim and inspecting the product, at its
discretion, do one of the following: repair, replace, or refund with the same or a
similar product (or part) of no lesser quality and ship it to the original purchaser at
Targus’ expense. As part of this inspection, proof of purchase will be required.
There is no charge for inspection. To make a warranty claim, please contact Targus
Australia or New Zealand (see details below), or return the product to the place of
purchase. The original purchaser must bear the cost of the delivery to Targus.
Under Australian and/or New Zealand Consumer Laws, in addition to any warranty
Targus gives, our products come with guarantees that cannot be excluded. You are
entitled to a replacement or refund for a major failure and compensation for any
other reasonably foreseeable loss or damage. You are entitled to have the products
repaired or replaced if they fail to be of acceptable quality and the failure does not
amount to a major failure.
For any warranty question, contact Targus Australia Pty. Ltd. (i) by mail at Suite 2,
Level 8, 5 Rider Boulevard, Rhodes NSW 2138, by phone AUS 1800 641 645 or
NZ 0800 633 222 or by Email: infoaust@targus.com. For additional information,
check out our website at targus.com/au/warranty.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
Hereby, Targus declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive: 2014/30/EU and
2014/35/EU.
Macbook users can use the System Preferences for Displays to adjust the external
monitors. OS-X allows configuration of all displays, including:
• Resolution up to
Single display mode:
- Dual Mode DisplayPort (DP++) or USB-C by DP alternative mode on
Thunderbolt 3 port: 4096 x 2160 p60 max.
Thunderbolt 3 port: 5188 x 2880 p60 max
Dual display mode:
User can connect second monitor to TBT 3 daisy chain port by,
1. Thunderbolt 3 monitor (resolution at 4096 x 2160 p60 max)
2. USB-C monitor with DP alt. mode supported (resolution at 4096 x 2160
p60 max)
3. DP via Targus ACA932 (resolution at 4096 x 2160 p60 max)
4. HDMI via Targus ACA933 (resolution at 4096 x 2160 p60 max)
5. VGA via Targus ACA934 (resolution at 1920 x 1200 max)
