NOTE: Begin these steps BEFORE inserting the LP-E card.
1
Connect your Pocket PC to a host PC using the
synchronizing cradle and cable that came with your Pocket
PC.
2
Insert the
Low Power Ethernet Card Installation CD into the
host PC.
WARNING: The host PC must already be actively connected to
your Pocket PC and have an established partnership.
3
Click
Start/Run on the host PC, then type
D:\SETUP
(Use the
drive letter of your CD-ROM drive in the place of
D:
).
Follow the instructions on the host PC.
NOTE: If your Pocket PC prompts you to confirm file replacing,
tap “Yes to All” to continue.
When complete, your Pocket PC displays the message
“Application Downloading Complete.”
4
Click
OK, then reset your Pocket PC to load the new
software.
Your Pocket PC then displays the Setup Complete screen.
5
Click
OK.
6
Remove your Pocket PC from it’s cradle.
7
Connect the LP-E card into an active Ethernet connection.
HINT: The host PC must be connected and currently logged into
the same network as your Pocket PC.
8
Insert the LP-E card into your Pocket PC’s CompactFlash
card slot.
NOTE: For instructions on how to insert the LP-E card into your
Pocket PC, refer to the
Low Power Ethernet Card User’s Guide
,
Chapter 3: Hardware Setup - Connecting the LP-E card to Your
Computer.
2
Summary of Contents for PA610U
Page 1: ...Installation Guide Mobile Computer Low Power Ethernet Card Targus Low Power Ethernet Card ...
Page 2: ......
Page 15: ......