Targus PA610U, Installation Manual

WINDOWS CE 

SETUP

Overview

This chapter describes how to install the LP-E card software
and set up a network connection for use with a mobile computer
running Windows CE v2.11 or greater.

HINT: Before installing the LP-E card, consult your network
administrator and back up all important data.

Software Installation

This chapter applies only to Windows CE-based mobile
computers. To install software for a Pocket PC, refer to Pocket
PC Setup, “Software Installation.”

HINT: Some mobile computers support a touch pad and not a
pen, so whenever these instructions say tap, substitute click, as
needed.

NOTE: Complete these steps for software installation BEFORE
inserting the LP-E card.

1

Connect your mobile computer to a host PC using the serial
cable that came with the device.

2

Insert the Low Power Ethernet Card Installation CD into the
host PC.

WARNING: The host PC must already be actively connected to
your Pocket PC and have an established partnership. 

3

Click 

Start/Run on the host PC, then type 

D:\SETUP

(Use the

drive letter of your CD-ROM drive in the place of

D:

).

Follow the instructions on the host PC.

7