Targus Wireless Stow-N-Go
TM
Keypad
Connecting the Receiver and Installing
the Default Drivers
To connect the receiver:
1. Remove the receiver from the back of the keypad.
2. Plug the USB receiver into an available USB port on your
computer.
For
Windows® 98SE
, follow any on-screen instructions to
complete the default driver installation.
For
Windows® Me/2000/XP/Vista
, the “Found NewHardware” or
“Auto-detect of a HID device” message will appear to indicate the
installation of the default driver.
NOTE: YOU MAY NEED TO ESTABLISH A COMMUNICATION LINK BETWEEN THE
KEYPAD AND THE RECEIVER. SEE “ESTABLISHING A COMMUNICATIONS LINK”.
Turning the Keypad On and Off
1. To power on the battery, use the on/off switch located on the back of
the keypad.
2. To power off the battery, use the on/off switch located on the back of
the keypad. This feature should beused when traveling to prevent
power loss.
3. To turn on the keypad, press the NumLock key, located directly
above the number seven key.
4. The keypad goes into sleep mode after 4 minutes of non-operation.
To wake the keypad, press the NumLock key.
5
