Heated Grips (if so equipped)
It is recommended that you wear gloves
when using the heated grip. If the heated
grip becomes too hot, turn it off.
To activate the heated grips, move
the switch into ON position.
Drift Cutters (if so equipped)
Drift Cutters break up snow drifts that are taller
than the auger housing and direct the snow into
the auger. Store the drift cutters on the auger
housing when not in use. Reposition drift cutters
so they face forward as shown. Wing nuts should
be fastened on the outside of the auger housing.
Differential Lock Trigger (if so equipped)
The differential is locked for maximum traction.
With the differential locked, power is applied
equally to both wheels/tracks.
The differential lock trigger is located on the
underside of the left handle. Squeeze the trigger
to release the differential lock for easier turning.
Steering Triggers (if so equipped)
Steering triggers are used to assist in steering the
snow blower. The triggers are located on the
underside of each handlebar. When a trigger is
squeezed, it disengages the drive wheel on that
side and allows the snow blower to turn in that
direction. With the drive clutch engaged, squeeze
the right trigger to turn right and squeeze the left
trigger to turn left.
It is easier to maneuver a non-running
snow blower with both triggers held in
simultaneously.
Fuel Shutoff Valve
Always operate the snow blower with the fuel shut-
off valve in the OPEN position. Close the valve
when you do not use the machine.
