5
Plug the USB adapter to the DATA PORT of ZYX-S2, and then connect to PC. Open ZYX
Assistant1.0.exe, the interface of this program is in the following figure.
Disconnect the ESC and motor, turn on the transmitter, power on the helicopter and ZYX-S2. Select
COM port in the software, and click
“Connect”. The status bar should show “Download Parameters
Completely
”, this means ZYX-S2 has been connected to the software successfully. Click “Setup”, and
setup your helicopter step by step.
Notice:
The parameters in
”Advanced” menu do not need to be changed generally, “Basic” menu is
enough for 3D flight.
If you are a experienced pilot, you can adjust
”Advanced” menu to obtain the desired feeling.
7. Check before first flight
Disconnect the ESC and motor, power on the transmitter and the helicopter, move all the stick
to check the servo direction.
Pick up helicopter and rotate it around its 3 axis, check the Gyro Compensation Direction.
