Seam-sealing and Repair
Seams must be sealed with a
silicone
-based sealer such as GE Silicone II clear
sealer. In a well-ventilated location, mix about
three tablespoons
into a tuna
can with about 6 tablespoons mineral spirits (paint thinner) or Coleman fuel/
white gas. Stir to dissolve and form a semi-viscous solution. Set up the tent
and seal the outside/topside seams over your living space. Paint the solution
on with a small foam brush for easy, smooth application. It’s also a good idea
to paint thicker swaths of silicone on the compartment floor in the area of your
sleeping pad to help reduce sliding, especially if you use an inflatable pad.
Small fabric tears can be patched with pure silicone and scrap fabric (included).
Condensation and Sag
Ventilation and fabric warmth are your best defenses against condensation.
Keep doors open as much possible and try to set up where it’s breezy. Look for
warmer and drier microclimates under trees and out of valleys and lake basins.
Nylon stretches (and sags) when the humidity goes up, night is falling, and/or
when it starts to rain.
Use the line tighteners to tighten the fabric
.
Key points to consider
• Push the arch poles out of sleeves and loops. Pulling the pole will result in
pole segment separation.
• The fabric will resist much stress but neither flame nor abrasion. Treat it
accordingly.
Thank you for your purchase and we sincerely hope that you enjoy your
Tarptent. Feedback is always welcome.
Tarptent
12213 Koswyn Ct.
Nevada City, CA 95959 USA
e-mail: info@tarptent.com
ph: 650-587-1548
Snowfall and Wind
A snow shovel is a necessity for any journey during snow season. Use it to
build snow walls and dig yourself out of heavy snow. Seek natural windbreaks
in trees and behind rock outcroppings to limit wind exposure.
Snowfall is best handled by ensuring that it slides off the shelter. Any residual
snow must then be supported by the structural integrity of the shelter. The
Scarp 1 is strong but not intended for areas with extreme snowfall, especially
heavy, wet snowfall which readily sticks to the canopy instead of sloughing
off. The angle of the flat part of the canopy is relatively shallow and you will
want to reach up and punch the underside of the interior, as often as necessary,
to prevent snow from accumulating on the canopy. Get out and shovel
periodically to clear snow from the canopy and perimeter. If snow is getting
hung up along the rear edge, it may be useful to drop or angle the center edge
strut to allow for easier sloughing.
Additional canopy support can be added using the pullouts as shown.
Inner Compartment
The inner compartment attaches to the outer fly structure via clips and rings.
The compartment is completely detachable and the outer fly can be used
standalone.
