19. Electronic motor
alignment
The display panel on the
ProSpot
allows for the electronic alignment of the projec-
tor’s motors. this procedure is performed by
tas
at the factory. It may be useful to
perform this procedure in the case of internal components being replaced.
Altering the factory settings may radically alter the functioning of the projector.
Carefully read all of the following prior to attempting any changes.
AdJ
This function allows for the calibration and adjustment of the colour wheel, the
gobos and effects (prism) into their correct standard position.
You may effect a calibration either via the display panel or via external signal.
19.1 Calibrating via an external signal source
A DMX512 control source must be connected to the
ProSpot
.
1) Press the
+
or
–
buttons to display
SPEC
(for special).
2) Press the
enter
button.
3) Press the
+
or
–
buttons to display AdJ (for adjustment).
4) Press the
enter
button to confirm your selection.
5) Press the
+
or
–
buttons to display
FCAL
(for fixture calibration).
6) Press the
enter
button to confirm your selection.
7) Press the
+
or
–
buttons to display
Colo
,
EFEC
,
rGob
,
Grot
.
8) Press the
enter
button.
menu enter
+
--
menu enter
+
--
menu enter
+
--
Attenzione!
Questo capitolo è da ritenersi di esclusivo utilizzo di tecnici e forso-
nale altamente specializzato
www.carlosmendoza.com.mx
