5. Operating voltage
The projector may operate at either 208, 230 or 240 V.at 50 or 60 Hz;
tas
presets
and frequency
(barring specific requests), a voltage of 230 V and a frequency of 50 Hz.
If this preset does not correspond with the conditions in your particular country of
operation, follow the instructions in the sections which follow.
Incorrect frequency and voltage selection will detrimentally affect the
operation of the projector.
5.1 Setting the operating frequency on the ballast of the ProSpot.
1) Remove the four screws (
A
) on the side plate of the projector’s base, using a
Philips head screwdriver; remove the plate, thereby allowing complete internal
access to the base of the
ProSpot
.
4) Locate the terminal block labeled 50 or 60Hz to which the cable determining ope-
rating frequency is attached.
5) Move this cable to either the 50 or 60Hz position as required.
6) After having moved the cable and tightened it firmly in place, replace the hou-
sing and refasten the screws (A).
www.carlosmendoza.com.mx
