3 – Cassette operations—Recording tapes from the PHONO deck
TASCAM CC-222
Owner’s Manual
17
The dubbing stops when playback reaches the end of
the CD, or when the tape reaches the end of its run
(one side in the case of single-sided (
u
) reverse
mode, both sides in the
j
reverse mode), which-
ever comes first.
Note that if the tape is set to auto-reverse, and the last
item recorded on one side of a tape was not com-
pletely recorded before the tape was reversed, that
item will be automatically repeated.
Also note that when the tape automatically reverses,
eight seconds are used as non-recorded time at the
beginning of the second side (the tape is in record
mode, but the CD does not play back), again to allow
for leader tape at the start of the cassette.
The dubbing process can also be stopped manually
with the
STOP
key of the cassette deck or the CD
deck. All other transport keys are disabled.
NOTE
Dubbing is not possible if: a cassette is not loaded, or a
CD is not loaded. It is not possible if the cassette is
write-protected, or if the CD is a recordable disc which
does not currently have any material recorded on it.
It is also not possible to enter the dubbing mode if the
tape is not in stop or record ready mode, or if the CD is
not in stop or pause mode.
Dubbing to tape from the middle of a CD
The above procedure describes the playback and
recording from the start of a disc (or the start of a
programmed playback list).
To record from a point other than the ones above:
1
Locate the disc to the point where the play-
back is to start.
2
Press the disc
PAUSE
key to pause playback
at the point where the playback is to start.
3
If recording is to start at the beginning of the
cassette, make sure the cassette is stopped,
otherwise, locate the cassette to the appropri-
ate position where recording is to start, and
enter record ready mode.
Using the headphones with the
MONITOR
switch set
to
1+2
will help here.
4
Press the
DUB 2
key. Playback starts on the
disc, and recording starts on the cassette.
Bypassing the INPUT level for dubbing
The
INPUT
control can be bypassed so that it has no
effect when dubbing, in the following way:
1
Press the
MENU
key until the
DUB>VOL
item appears.
2
Turn the dial to select either
THRU
(the con-
trol is bypassed and disabled) or
ON
(the
control is enabled).
NOTE
This setting applies only to dubbing procedures, not to
other recordings.
It is not possible to make this menu setting (or any
other menu settings) when dubbing is actually taking
place.
Recording tapes from the PHONO deck
To record from an external record deck connected
through the
RIAA PHONO
inputs:
1
Prepare for recording as described above
(load a tape, set the
REV MODE
, etc.).
2
Press the
MENU
key until the
PHONO >
xxxx
menu item is shown.
If the display does not show
PHONO >
TAPE
, turn the
MULTI DIAL
(or press the
SKIP
keys on the remote control) until it does
and press the
MULTI DIAL
(or
ENTER
on the
remote control unit).
3
Press the
PHONO
. The
PHONO
indica-
tor lights on the display.
If the tape is currently in stop mode, the tape
rewinds, and the deck enters record ready
mode (about eight seconds from the start of
the cassette, to allow for leader tape).
If the tape deck is already in record ready
mode, it will remain in record ready mode.
4
Start playback of the record.
5
Start recording with either the PLAY or
PAUSE key.
