TASCAM CD-200BT
19
4 – CD playback
Playback
The following procedures assume that the necessary connec-
tions have been completed, the unit’s power has been turned
ON and CD has been loaded.
To start playback, press the PLAY/PAUSE button on the main
unit or the remote control.
8
Stopping playback
Press the STOP button on the main unit or the remote
control.
8
Pausing playback
Press the PLAY/PAUSE button on the main unit or the
remote control.
In this manual, unless stated otherwise, explanations are given
assuming that the playback mode is continuous. (See “Playback
Selecting a track
There are two ways to select a track. You can move (skip) to the
previous or next track, or you can select a track directly by its
track number.
Skipping to the next or previous track
Use the main unit SEARCH
m
/
,
[
.
/
/
] buttons or
the remote search (
m
/
.
and
/
/
,
) buttons to skip to
tracks.
After selecting the track, press the PLAY/PAUSE button on the
main unit or the remote control to start track playback.
NOTE
If you press the main unit
SEARCH
m
/
,
buttons or the
remote search (
m
/
.
and
/
/
,
) buttons during
playback, playback will resume after skipping tracks.
Selecting by track number
Use the number (0–9) buttons on the remote control to directly
select tracks for playback.
Track numbers can have up to two digits for audio CDs and up
to three digits for data CDs.
1. Use the number (0–9) buttons on the remote control to
input the track number. Enter the track number starting from
the largest digit.
To select track 1:
Press the 1 button one time.
To select track 12:
Press the 1 button followed by the 2 button.
2. Press the PLAY/PAUSE button on the main unit or the
remote control. The selected track begins to play.
If you press the STOP button on the main unit or the remote
control, the display stops showing the track number input
and the display returns to its previous state.
NOTE
•
When the playback area is set to
ALL PLAY
, use the
FOLDER
g
/
t
buttons on the main unit or the remote
control to skip between folders.
•
When in program or random mode, you cannot use the
number
(0–9)
buttons to select tracks.
