TASCAM CD-200iL
13
3 – Preparations
Making connections
Examples of connections that can be made with a CD-200iL are shown below.
8
Precautions before making connections
• Before connecting other devices, read their operation manuals carefully and connect them properly.
• Turn the power OFF or set the power to standby for this unit and all units to be connected to it.
• Set up all the units so that they are powered from the same line. When using a power strip, for example, use a thick cable with a high
current capacity to reduce fluctuation of the power voltage.
ANALOG
IN
(UNBALANCED)
DIGITAL
IN
(OPTICAL)
DIGITAL
IN
(COAXIAL)
Mixer,
Recorder,
Amplifier, or
other device
Digital mixer,
Digital recorder,
Digital amplifier, or
other device
8
Connecting analog audio devices
Connect the analog output jacks of this unit to the input jacks
of a stereo amplifier, mixer, recorder or other device with analog
inputs.
NOTE
•
Cables are not included with this unit.
•
Do not bundle RCA cables with power cords or speaker
cables. Doing so could cause reduced audio quality or noise.
8
Connecting digital audio devices
Connect a digital output jack (coaxial or optical) of this unit
to the input jack of a stereo amplifier, mixer, recorder or other
device with a digital input.
NOTE
•
During data CD playback, the sampling frequency of this
unit’s digital output is converted to 44.1 kHz before output
regardless of the sampling frequency of the playback file.
•
This unit cannot convert analog audio input through the
AUX IN
jack into digital audio and output it.
•
If the pitch control function is on during CD playback, the
sampling frequency of the digital audio output signal is
changed by an amount equivalent to the pitch control
value. In this case, some devices might not be able to accept
digital audio signals output from this unit.
