28
TASCAM CD-200SB
4 – Playback
NOTE
•
After pressing the
DISPLAY [SHIFT]
button on the main unit
or the
DISPLAY
button on the remote control, the currently
selected type of information to be shown on the main
display appears for two seconds as follows.
Track elapsed time:
ELAPSED
Track remaining time:
REMAIN
Total remaining time:
T REMAIN
Album/track title:
TITLE
Album/track artist:
ARTIST
File name:
FILENAME
•
The text information that can be shown on the display is CD
text information for audio CDs, ID3 tag information for data
CDs and ID3, WMA and AAC tag information for SD cards
and USB flash drives.
When information is not included for a disc or file,
NO
TITLE
(title information) or
NO NAME
(artist information)
is shown. If the information contains characters that cannot
be displayed, those characters are replaced by
_
.
•
When an audio CD is in programmed playback mode the
elapsed time and remaining time of the entire program is
shown.
•
The display contents setting is retained even when the
power is turned off.
•
The number of songs and track numbers within a folder
might not match on SD cards and USB flash drives that have
been written on by a Mac. This is an existing problem with
Mac system files, but it will not affect playback on this unit.
Pitch control (with CDs only)
Using pitch control playback, CDs can be played back at a
different pitch (sound frequency and playback speed).
Follow the procedures below to use pitch control playback.
1. Press the REPEAT [PITCH] button while pressing and
holding the DISPLAY [SHIFT] button on the main unit or
press the PITCH button on the remote control to turn pitch
control ON. The current pitch control value is shown at this
time.
2. Use the FOLDER
g
/
t
[PITCH −/+, / ] buttons on the
main unit or the PITCH –/+ button on the remote control to
set the pitch in 0.5% units in a range of ±14.0%.
o
To turn pitch control playback OFF:
Press the REPEAT [PITCH] button while pressing and
holding the DISPLAY [SHIFT] button on the main unit or
press the PITCH button on the remote control.
NOTE
•
During playback, turning pitch control playback ON or OFF
might cause the playback sound to skip momentarily.
•
Using pitch control playback with a data CD (MP3, WAV)
sometimes causes the playback sound to skip.
•
Digital output is possible when the pitch control function is
ON during playback of MP3 and WAV files on audio CDs, but
the sampling frequency is changed by an amount propor-
tional to the pitch control value. When pitch control is ON,
therefore, some equipment might not be able to receive the
digital output signal from the CD-200SB.
•
The pitch control function cannot be used with SD cards and
USB flash drives.
