4 • Advanced Operations—Voice Reduce function
26
TASCAM CD-302
1
Press the
PRESET
key.
2
Select
09 SAMP/R
(
SAMP_R
) using the dial or
numeric keys.
3
Press the
ENTER
key.
4
Select
On
or
Off
using the dial.
5
Press the
ENTER
key.
However, even if the sampling point recall is set to
off, memorized sample data can still be loaded later:
1
Recall the memory (see 4.10.2, “Recalling a
memory”). If sample points have been stored
in the memory, the
IN
and
OUT
keys will flash
three times.
2
Pause playback.
3
Press and hold the
OUT
key for more than two
seconds.
The sample data are loaded, and the
IN
and
OUT
keys will light.
4.10.6 Clearing memories
It is possible to clear all memories together, or clear
them individually.
To clear individual memories:
1
Recall the memory.
2
M
will show on the display.
3
Press and hold the
MEMORY
key
J
for two
seconds or longer.
4
The
M
in the display will go out.
To clear all memories.
1
Press the
PRESET
key.
2
Select
24 ALL/CL
(
ALL_CL
)
using the dial or
numeric keys.
3
Press the
ENTER
key. The display will show
-SuRE-
(
-SURE-
).
4
Press the
ENTER
key to confirm the deletion of
all memories.
NOTE
If you are clearing all memories and then turning off
the power, wait a few seconds between pressing the
ENTER key and turning off the power.
4.11 Voice Reduce function
This function lowers the volume of the vocal part of
the material being played back when enabled. Note
that this may work better on some recordings than
others.
1
Press the
PRESET
key.
2
Select
10 VOICE/R
(
VOICE_R
) using the dial
or numeric keys.
3
Press the
ENTER
key.
4
Select
On
or
Off
using the dial.
5
Press the
ENTER
key to confirm this setting.
4.12 Programmed playback
Add up to 30 tracks to a program for programmed
playback in a series of program steps.
Even when the power is turned off, if you have set a
programmed playback order set and enabled timer
play, programmed playback will start when the unit
is turned on, as the program is stored in memory.
4.12.1 Setting the program steps
This adds tracks as program steps in a new program.
1
Press the
PRESET
key.
2
Select
11 PROG
(
PROG
) using the dial or
numeric keys.
3
Press the
ENTER
key. The program step num-
ber and the track number are shown on the
display.
4
Use the
SKIP
keys
C
to select the track to be
played as the currently-shown program step.
5
Press the
ENTER
key to confirm the entry.
6
Repeat 4 and 5 above for as many steps as will
be entered into the program.
7
To finish the program entry sequence, press
the
PRESET
or
ENTER
key (or any key except
the
SKIP
keys).
4.12.2 Adding tracks to the middle of a
program
When you have created a program, you can insert
tracks as new program steps part of the way through
the program.
1
Press the
PRESET
key.
