TASCAM CD-400U DAB
41
E
9 – Other functions
Checking the firmware version
You can check the version of the system firmware used by this
unit.
1.
Select the
Information
item on the
Menu
screen to open
a screen where you can check the firmware version. (see
“Menu operation procedures” on page 18)
MCU ver 1.01
Information
The firmware version confirmation screen shows informa-
tion about the system firmware version.
2.
Press the main unit MULTI JOG dial or remote control ENTER
button to return to the
Menu
screen.
Restoring factory default settings
You can restore the various settings stored in the backup memo-
ry of the unit to their factory default values.
Use the following menu procedures to do so.
1.
Select the
Factory Preset
item on the
Menu
screen.
“Menu operation procedures” on page 18)
2.
Press the main unit MULTI JOG dial or remote control ENTER
button.
A confirmation message will appear.
OK?
Factory Preset
NOTE
To cancel, press the main unit CLEAR button.
3.
Press the main unit MULTI JOG dial or remote control ENTER
button to reset the unit to its factory settings.
After it completes, the
Menu
screen will reopen.
Summary of Contents for CD-400U DAB
Page 213: ...TASCAM CD 400U 213...
Page 214: ...214 TASCAM CD 400U...