TASCAM CD-400U
21
3 – Preparation
Inserting and removing discs
Inserting discs
Insert the disc part way with its labeled side up.
Push the disc in further until just before it disappears. It will au-
tomatically be drawn in to the slot.
CAUTION
i
Discs cannot be inserted when the power is off.
i
If the disc becomes stuck during insertion, for example, and is
difficult to push, do not try to force it in. Pull the disc out once
and press the EJECT button. Then, try inserting it again. (Try-
ing to force the disc in could scratch it or damage the unit.)
i
If a disc other than a playable CD is inserted or a disc is insert-
ed upside down, the unit will automatically eject it.
i
8cm CDs cannot be used. If an 8cm CD is inserted, it will auto-
matically be ejected.
Ejecting discs
Press the main unit or remote control EJECT button.
When the disc is partially ejected, hold the edge and pull it out.
CAUTION
When the power is off, the main unit and remote control
EJECT buttons will not function.
Forcing disc ejection
Press and hold the EJECT button for at least 10 seconds to force
the disc to eject. (This will eject discs even when
No Disc
ap-
pears on the Home Screen)
Inserting and removing SD cards
Inserting SD cards
Insert an SD card into the SD card slot on the front of the unit to
enable playback and dubbing by this unit.
NOTE
SD cards can be inserted whether or not the unit is on or off.
0
Inserted SD cards with the correct orientation.
0
The label should be up and the connector should be inserted
toward the back.
Removing SD cards
Turn the unit off or stop operation before removing an SD card.
CAUTION
Do not remove an SD card when the unit is operating (includ-
ing playing back or writing data to the SD card). Doing so
could cause proper dubbing to fail, data to be lost, and sud-
den loud noises from monitoring equipment, which might
damage the equipment, harm hearing or cause other trouble.
1.
Press the SD card in gently to make it to come forward.
2.
Pull the SD card out by hand.
SD card write protection switches
SD cards have write-protection switches that prevent writing
new data to them.
If you slide the write-protection switch to the LOCK position,
dubbing will not be possible.
Remove write-protection to use the dubbing (copying) function.
