Tascam CD-6010, Owner'S Manual

TASCAM CD-6010

21

5 – Operation

Loading discs 

Inserting a disc

To load a CD, press the 

OPEN/CLOSE

 button on the unit 

or the 

EJECT

 button on the remote control to open the 

disc tray. Load the disc with its label side up.
Press the 

OPEN/CLOSE

 button or the 

EJECT

 button again 

to close the disc tray. 
After a disc is loaded, the player will read its information. If 

it is an audio CD, the display will show the total number of 

tracks and total playback time. If it is a data CD, the display 

will show the total number of tracks in the current folder.

NOTE

You can also press the 

Á

 [PLAY] button to close the disc 

tray and start playback immediately instead of pressing the 

OPEN/CLOSE button or the EJECT button again to close the 

disc tray.

Ejecting a disc

Press the 

OPEN/CLOSE

 button on the player or 

EJECT

button on the remote . 
Remove the disc after the tray opens. 

NOTE

In order to reduce the disc ejection time, the tray opens 

• 

before the disc stops spinning completely. 
The OPEN/CLOSE button functions when the power is ON. 

• 

If you must remove a disc when the power is OFF, insert 

a paperclip or similar stiff rod into the hole beneath the 

tray and push to open the tray.

Tray lock function 

The tray lock function allows you to disable the operation 

of the 

OPEN/CLOSE

 button on the player during playback 

and when paused in order to prevent playback from being 

interrupted if this button is pressed accidentally.
To turn the tray lock function on, set the 

02 TRAY

 menu 

item to 

LOK

 (default value:

 OFF

). 

NOTE

The tray lock function on/off setting is maintained even 

when the player’s power is turned off. 

Playing back a CD

The following procedures assume that the necessary 

connections have been completed, the player’s power has 

been turned on and a CD (audio or data) has been loaded.
To start playback, press the 

Á

[PLAY]

 button on the 

player or the 

Á

PLAY

 button on the remote. 

Stopping playback

Press the 

ª

STOP [INTRO CHECK]

 button on the player 

or the 

ª

STOP

 button on the remote.

Pausing playback

Press the 

π

 [

PAUSE] 

button on the player or the 

π

PAUSE

button on the remote. 
To restart playback, press the 

Á

[PLAY]

 button on the 

player or the 

Á

PLAY

 button on the remote.

NOTE

In this manual, unless stated otherwise, explanations assume 

that continuous playback mode is enabled. (See “Playback 

modes” on page 23.)