26
TASCAM CD-6010
6 – Various Playback Functions
Repeat playback
You can repeatedly play back all tracks or repeatedly
play back a specified region within a track (A-B repeat
playback).
Ordinary repeat playback
When the repeat playback function is on, behavior
depends on the playback mode.
All track playback (ordinary playback) mode: the entire
•
disc is played back repeatedly
Single track playback mode: the current track is played
•
back repeatedly
Program playback mode: all the tracks in the program
•
are played back repeatedly
Random playback mode: all the tracks on the disc are
•
played back at random repeatedly
Use one of the following procedures to turn the repeat
playback function on.
Using the front panel buttons:
When in shift mode (
SHIFT
indicator lit), press the
PLAY
MODE
[REPEAT]
button.
REPEAT
appears of the top of
the display when repeat mode is activated. You can also
do this by pressing the
PLAY MODE
[REPEAT]
button
while pressing and holding the SHIFT button.
Using the remote control:
Press the remote
REPEAT
button.
REPEAT
appears of
the top of the display when repeat mode is activated.
Use one of the following procedures to turn the repeat
playback function off.
When the player is in shift mode (
•
SHIFT
indicator lit),
press the
PLAY MODE
[REPEAT]
button again until
REPEAT
disappears from the top of the screen. You
can also do this by pressing the
PLAY MODE
[REPEAT]
button while pressing and holding the SHIFT button.
Press the
•
REPEAT
button on the remote until
REPEAT
disappears from the top of the screen.
NOTE
The repeat playback setting is retained even when the power
is turned off.
A-B repeat playback
You can specify a desired interval (A-B) within a track to be
played back repeatedly. Use the following procedures to
enable A-B repeat playback.
1 During playback or when paused, when the player is
in shift mode (SHIFT indicator lit), press and hold the
PLAY MODE
[REPEAT]
button
on the player, or press
and hold the
PLAY MODE
[REPEAT]
button while
pressing the SHIFT button, or press and hold the
REPEAT button on the remote to activate A-B repeat
mode.
REPEAT
will blink at the top of the display.
2 Press the TRACK SKIP/DATA knob on the player or
the REPEAT button on the remote at the beginning
of the interval that you want to repeat (A point).
A-B
will blink at the top of the display.
3 Once again, press the TRACK SKIP/DATA knob on the
player or the REPEAT button on the remote at the
end of the interval that you want to repeat (B point).
Repeat playback between the A and B points will
begin, and
A-B
will stop blinking and continue to
appear at the top of the display.
4 To end A-B repeat playback, press the
ª
STOP [INTRO
CHECK] button on the player or the
ª
STOP button
on the remote.
NOTE
A-B repeat playback cannot be used with a data CD.
•
Once playback reaches the B point, playback will restart
•
from the A point.
A-B repeat playback across more than one track is not
•
possible.
