Tascam CD-601MKII, Owner'S Manual

TASCAM  CD-601MKII

11

NAMES & FUNCTIONS OF PARTS

ແ

WORD SYNC IN terminal

This terminal is for inputting the word clock signal. When 
the CD player is operated referenced to an external 
clock (EXT), the word clock that is input to this terminal 
becomes the reference clock. 

ໂ

WORD SYNC THRU terminal

This terminal is for outputting the input word clock signal, 
allowing it to be sent to other digital equipment as it is.

ໃ

DIGITAL OUTPUTS - SPDIF terminal

This co-axial digital output terminal is for outputting the 
disc playback signal in IEC60958-3 (S/PDIF) format. In 
the default setting, the playback signal is output in either 
of online playback and monitor playback. 

ໄ

DIGITAL OUTPUTS - AES/EBU terminal

This digital output terminal is for outputting the disc 
playback signal in IEC60958-4 (AES/EBU) format. In the 
default setting, the playback signal is output in either of 
online playback and monitor playback. 

໅

ANALOG OUTPUTS - UNBALANCED (L, R) terminals

This analog unbalance output terminal (RCA pin) is for 
outputting the disc playback signal. In the default setting, 
the playback signal is output in either of online playback 
and monitor playback. 

ໆ

ANALOG OUTPUTS - BALANCED (L, R) terminals

This analog unbalance output terminal is for outputting 
the disc playback signal. 
In the default setting, the playback signal is output in 
either of online playback and monitor playback. 

໇

CAL knobs

These semi-fixed control knobs are for the analog 
balance output terminals. 
These knobs allow you to fine-tune the output levels of 
the L and R channels individually. 

່

REMOTE (PARALLEL) terminal

This D-Sub 37-pin connector is used for performing fader 
start and other external controls. (

→

 page 25 “Parallel 

Control”)

້

REMOTE (SERIAL) terminal

This terminal is for connecting the Remote Control Unit 
RC-601MKII (sold separately). 
This terminal is an RS-232C-compliant serial control 
terminal. So, a PC or other device can be connected 
to this terminal to control the CD player. (

→

 page 26 

“Control from the RS-232C interface”)

໊

POWER switch

Switches the power ON/OFF. 

໋

~ IN connector

The power cable (supplied) is connected to this 
connector.

Rear Panel

CD-601MKII_Eng.indd   11

3/26/2005   7:39:47 PM